Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 95)

Manual revision 006 Section 5: Routine Maintenance and Calibration SBE 19plus V2

Recharging Optional Nickel Metal Hydride Batteries

See the NiMH Battery Charger and Battery Pack manual for complete

details on charging, error messages, battery specifications, etc.

1. Remove the battery end cap (end cap without connectors):

A. Wipe the outside of the end cap and housing dry, being careful to

remove any water at the seam between them.

B. Unthread the end cap by rotating counter-clockwise (use a wrench on

the white plastic bar if necessary).

C. Remove any water from the O-ring mating surfaces inside the

housing with a lint-free cloth or tissue.

D. Put the end cap aside, being careful to protect the O-ring from

damage or contamination.

2. Remove the battery pack from the housing:

A. The protective plastic plate over the battery cover plate prevents you

from completely removing the cap screws that connect the battery

pack to the 19plus V2 battery posts in one step. Each of the screws is

12 mm (1/2 inch) long, but the clearance between the cover plate and

plastic plate is only 6 mm (1/4 inch). Unscrew each of the three cap

screws just until they hit the bottom of the protective plastic plate.

The battery pack will walk out of the housing approximately 6 mm

(1/4 inch) because of the spring contacts at the bottom of the battery

compartment. Unscrew the cap screws again. The battery pack

will walk out of the housing again, and should now be disconnected

from the battery posts.

B. Pull on the cord to remove the battery pack from the housing.

3. Recharge the batteries:

A. Plug the battery charger into a suitable power source and turn on

power to the charger.

B. Connect the charger cable to the battery pack and charger.

The LED should show READY, and display the battery type and

measured voltage.

C. Press the Discharge button. The LED should show DISCHARGE.

This starts the discharge cycle, which discharges any remaining

battery capacity. Repeatedly charging without discharging may

damage the battery pack. The Discharge cycle takes approximately

110 minutes. When discharging is complete, the LED should

show EMPTY.

D. Press the Charge button. The LED should show Fast Charge

(it may also show WARM-UP CHARGE, REFILL CHARGE, and/or

TOP OFF during the charge cycle). The Charge cycle takes

approximately 2 hours. When charging is complete, the LED should

show BATTERY FULL.

E. Turn off power to the charger.

F. Disconnect the battery pack from the charger and the charger from

the power source.

Unthread cap

by rotating

counter-

clockwise

Screw

9-cell

Battery pack

Note:

If desired, you can recharge the NiMH battery pack while it is in

the housing. Skip Steps 2 and 4 if recharging in the housing.

WARNING!

Do not disconnect the battery while the

Charger Active lamp is on. Doing so

may cause a small spark.

Power

switch

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 123 124

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 95

Comentários a estes Manuais