Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 22)

Manual revision 006 Section 2: Description of SBE 19plus V2 SBE 19plus V2

Shown below is the vertical mount plumbing arrangement of a 19plus V2

configured with the optional SBE 5T titanium or 5P plastic pump, SBE 43

dissolved oxygen (DO) sensor, and SBE 18 pH sensor. Note that the SBE 43 is

plumbed into the system between the conductivity cell outlet and the Y-fitting.

The SBE 18 is not connected to the plumbing.

Note:

Sea-Bird recommends use of

the pH sensor on the 19plus V2

only when the 19plus V2 is in

Profiling mode (MP).

Air bleed valve detail

Note: Periodically clean air

bleed valve to ensure

proper functioning.

0.5 mm (0.02 in.)

• Main plumbing is 13 mm ID x 19 mm OD

(1/2 inch x 3/4 inch) Tygon tubing.

• A 13 mm (1/2 inch) long piece of

9.5 mm ID x 13 mm OD (3/8 inch x 1/2 inch)

Tygon tubing to provide tight seals to the main

plumbing is installed:

- on the SBE 43 intake and exhaust, and

on the conductivity cell exhaust when optional

anti-foul fittings are installed on the 19plus V2.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 123 124

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 22