Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 85)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

Uploading Data

1. Double click on SeatermV2.exe. The main screen appears.

2. In the Instruments menu, select SBE 19plus V2. Seaterm232 opens.

3. Seaterm232 will try to automatically connect to the 19plus V2. As it

connects, it sends GetHD and displays the response. Seaterm232 also fills

the Send Commands window with the correct list of commands for your

19plus V2. If there is no communication:

A. In the Communications menu, select Configure. The Serial Port

Configuration dialog box appears. Select the Comm port and baud

rate for communication, and click OK.

B. In the Communications menu, select Connect (if Connect is grayed

out, select Disconnect and reconnect).

C. If there is still no communication, check cabling between the

computer and 19plus V2.

D. If there is still no communication, repeat Step A with a different baud

rate and/or comm port, and try to connect again. Note that the

factory-set baud rate is documented on the Configuration Sheet.

4. Command the 19plus V2 to stop data logging by the method applicable to

your instrument’s setup:

• Pressing the Enter key, typing Stop, and pressing the Enter key again,

• Moving the magnetic switch to the Off position (only applicable in

Profiling mode, if IgnoreSwitch=N)

5. Display 19plus V2 status information by typing DS and pressing the Enter

key. The display looks like this (if in Profiling mode):

SBE 19plus V 2.3 SERIAL NO. 4000 15 Mar 2011 14:02:13

vbatt = 10.1, vlith = 8.9, ioper = 61.9 ma, ipump = 20.8 ma,

iext01 = 76.2 ma

status = not logging

number of scans to average = 1

samples = 5000, free = 4381542, casts = 1

mode = profile, minimum cond freq = 3000, pump delay = 60 sec

autorun = no, ignore magnetic switch = no

battery type = alkaline, battery cutoff = 7.5 volts

pressure sensor = strain gauge, range = 1000.0

SBE 38 = no, WETLABS = no, OPTODE = no, Gas Tension Device = no

Ext Volt 0 = yes, Ext Volt 1 = yes

Ext Volt 2 = no, Ext Volt 3 = no

Ext Volt 4 = no, Ext Volt 5 = no

echo characters = yes

output format = converted decimal

output salinity = no, output sound velocity = no

Verify that the status shows status = not logging.

Note:

Data may be uploaded during

deployment or after recovery. If

uploading after recovery, connect the

I/O cable as described in Section 3:

Power and Communications Test.

Note:

You may need to send Stop several

times to get the 19plus V2 to respond.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 123 124

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 85

Comentários a estes Manuais