Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 86)

Manual revision 006 Section 4: Deploying and Operating SBE 19plus V2 SBE 19plus V2

6. Click Upload to upload stored data. Seaterm232 responds as follows:

A. Seaterm232 sends GetSD and displays the response. GetSD provides

information on the instrument status, and number of samples in

memory.

B. Seaterm232 sends DH and displays the response. DH provides

information on the headers in memory.

C. In the Save As dialog box, enter the desired upload file name and

click OK. The upload file has a .XML extension.

D. An Upload Data dialog box appears:

Make the desired selections.

Note:

If binary upload is selected,

Seaterm232 uploads the data in binary

and then converts it to ASCII text,

resulting in a data file that is identical

to one uploaded in ASCII text.

Bytes 21334368

Samples 1939488

SamplesFree 4042161

SampleLength 11

Profiles 22

C:\UploadTest.xml

Defines data upload type and range:

• All data as a single file – All data is uploaded

into 1 file.

• All data separated by cast (Profiling mode only)

- All data uploaded. Separate file is written

for each cast, with 3-digit cast identification

number (001 to 301) appended to user-selected

file name.

• By cast number range (Profiling mode only) –

Enter beginning cast number and total number

of casts. Separate file is written for each cast,

with 3-digit cast identification number (001 to

301) appended to user-selected file name.

• By scan number range – Enter beginning scan

(sample) number and total number of scans. All

data within range is uploaded into 1 file.

• By address range – Enter beginning byte

number and total number of bytes. Note that first

byte in memory is byte 0. All data within range is

uploaded into 1 file.

• From a single cast (Profiling mode only) – Enter

cast number. All data from that cast is uploaded

into 1 file.

To change upload file name selected in Step C

above, click Browse to navigate to desired upload

file path and name. Upload file has a .xml

extension. After Seaterm232 uploads data into

.xml file, it automatically converts .xml file to .hex

file (same file name, different extension), which is

compatible with Seasave and SBE Data

Processing.

Select number of bytes uploaded in each block.

Seaterm232 uploads data in blocks, and

calculates a checksum at end of each block. If

block fails checksum verification, Seaterm232

tries to upload block of data again, cutting block

size in half.

Select to enable ASCII text or

binary upload. Binary is

approximately twice as fast.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 123 124

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 86

Comentários a estes Manuais