
7
Auxiliary Sensor (0 – 5V analog)
No
t Working (no signal) (continued)
• Test the voltage channel with a ‘D’ Cell battery
– Referencing the end cap drawing for the SBE 9plus, connect the
positive terminal to signal and the negative terminal to signal
ground
– A new ‘D’ cell should read approximately 2800 on the deck unit
display or 1.5VDC for the voltage channel in Seasave
• Check that power is being supplied to the sensor
– Referencing the end cap drawing for the SBE 9plus,
connect a
voltmeter between pins 1 and 6 of the 6-pin connector
– There should be approximately 14VDC between pins 1 and 6 with
the deck unit powered on
Comentários a estes Manuais