Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 9)

Section 3: Preparing SBE 38 for Deployment

Section 3:

Preparing SBE 38 for Deployment

This section describes the software installation and the pre-check procedure

for preparing the SBE 38 for deployment.

Installing Software

Sea-Bird recommends the following minimum system requirements for

installing the software: Windows 2000 or later, 500 MHz processor,

256 MB RAM, and 90 MB free disk space for installation. Although

SEASOFT-Win32 was designed to work with a PC running Win 2000/XP;

extensive testing has not shown any compatibility problems when using the

software with a PC running Windows Vista.

If not already installed, install Sea-Bird software programs on your computer

using the supplied software CD:

1. Insert the CD in your CD drive.

2. Install software: Double click on Seasoft-Win32_date.exe (date is the

date that version of the software was created). Follow the dialog box

directions to install the software. The installation program allows you to

install the desired components. Install all the components, or just

install SEATERM for now.

The default location for the software is c:\Program Files\Sea-Bird. Within that

folder is a sub-directory for each program.

Power and Communications Test

Test Setup

1. If applicable, remove locking sleeve and dummy plug from bulkhead

connector:

A. By hand, unscrew the locking sleeve from the SBE 38’s bulkhead

connector. If you must use a wrench or pliers, be careful not to

loosen the bulkhead connector instead of the locking sleeve.

B. Remove the dummy plug from the SBE 38’s bulkhead connector by

pulling the plug firmly away from the connector.

2. Install the Sea-Bird I/O cable on the SBE 38:

• XSG Connector (shown in photos) - Align the raised bump on the

side of the connector with the large pin (pin 1 - ground) on the

SBE 38.

• MCBH Connector (optional) – Align the pins.

3. Connect the I/O cable connector to your computer’s serial port.

4. Connect the I/O cable battery terminal clip to a 9-volt battery. Note that

the 9-volt battery supplied with the SBE 38 will provide approximately

50 hours of operation.

Note:

It is possible to use the SBE 38

without SEATERM by sending direct

commands from a dumb terminal or

terminal emulator, such as Windows

HyperTerminal.

Cable

Locking

sleeve

Dummy plug

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Sea-Bird Electronics SBE 38