Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 18)

Section 4: Deploying and Operating RS-232 SBE 38

Data Formats

Converted Data (Format=C)

ttt.ttt

where:

t = temperature (degrees Celsius, ITS-90)

Number of digits to right of decimal point is defined by Digits=.

Raw Data (Format=R)

nnnnnn.n

where:

n= counts

Deployment

1. Install the I/O cable:

A. Lightly lubricate the inside of the cable connector with silicone

grease (DC-4 or equivalent).

B. XSG Connector (shown in photo) - Install the cable connector,

aligning the raised bump on the side of the connector with the large

pin (pin 1 - ground) on the SBE 38. Remove any trapped air by

burping or gently squeezing the connector near the top and moving

your fingers toward the end cap. OR

MCBH Connector (optional) – Install the cable connector,

aligning the pins.

C. Place the locking sleeve over the connector. Tighten the locking

sleeve finger tight only. Do not overtighten the locking sleeve and

do not use a wrench or pliers.

2. Mount the SBE 38.

3. Verify that the hardware and external fittings are secure.

4. Use one of the following sequences to start sampling:

• If AutoRun=N: Send Go to start sampling continuously now, or TS

or TH to take a single sample.

• If AutoRun=Y: Apply power to start sampling continuously now.

5. Deploy the SBE 38.

Notes:

• Each line of output is followed by

a carriage return and line feed.

• For converted data, leading zeros

for temperature output are

suppressed, except for one zero

to the left of the decimal point

(for example, 0.1034).

• See Appendix III: RS-485

Interface for data output format

for an SBE 38 with optional

RS-485 interface.

CAUTION:

Do not use WD-40 or other

petroleum-based lubricants, as they

will damage the connector.

Locking sleeve

I/O cable

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Sea-Bird Electronics SBE 38