Sea-Bird Electronics SBE 38 Manual do Utilizador descarregar pdf (Página 37)

Section 4: Setting Up MicroTSG SBE 45

Operating Commands

Operating commands configure the MicroTSG’s response upon waking up,

and direct the MicroTSG to sample data once or at pre-programmed intervals.

Interval=x x= interval (seconds) between samples

(maximum 32767 seconds). MicroTSG

samples at this interval, and does not enter

quiescent (sleep) state between samples.

Minimum time between samples determined by

NCycles=, desired calculated parameters

(salinity, etc.), and baud rate; see Sample

Timing and Baud Rate, Cable Length, Power,

and Data Transmission Rate

in Section 2:

Description of MicroTSG.

AutoOff=x (Functional only if J1 jumper on PCB is in

Normal position)

x=Y: Go to sleep (enter quiescent state) if

2 minutes have elapsed without receiving a

command or without sampling data.

x= N: Do not automatically go to sleep.

AutoRun=x x=Y or N: Interacts with SingleSample= and

J1 jumper setting, as described in

table below.

SingleSample=x x=Y or N: Interacts with AutoRun= and J1

jumper setting, as described in table below.

Go Start sampling, as defined by SingleSample=

and Interval=.

Only applicable if:

• AutoRun=N, or

• AutoRun=Y and you previously sent Stop

to stop sampling.

Stop Stop sampling. Press Enter key to get

S> prompt before entering Stop.

J1 Jumper AutoRun SingleSample Effect

Y or N

Wake up (when Connect on Toolbar clicked or Enter key pressed while asleep) state

and wait for command.

Y N

Wake up (when Connect on Toolbar clicked or Enter key pressed while asleep) and

sample at rate specified by Interval=.

To stop sampling and get S> prompt, type Stop and press Enter key.

Normal

(pins 2

and 3)

Y Y

Wake up (when Connect on Toolbar clicked or Enter key pressed while asleep), take

and output single sample, and automatically go to sleep. To wake up and get S>

prompt, type Stop and press Enter key. Referred to as Serial Line Sync Mode.

Y or N Wake up when power applied and wait for command.

Y N

Wake up when power applied and sample at rate specified by Interval= until power

removed. Required settings for MicroTSG in 3-wire (power, ground, and

transmit) configuration or when using MicroTSG with Interface Box.

Autopower

(pins 1

and 2)

Y Y

Wake up when power applied and take and output a single sample. Wait for another

command until power removed.

Note:

If the MicroTSG is sampling data and

the external voltage is less than

6.15 volts for ten consecutive scans,

the MicroTSG halts logging.

Note:

If the total time required for the sample

is greater than Interval=, the

MicroTSG begins the next sample as

soon as it finishes transmitting the

current sample.

Note:

You may need to send Stop several

times to get the MicroTSG to respond.

This is most likely to occur if sampling

with a small Interval=.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 103 104

Comentários a estes Manuais

Sem comentários

Sea-Bird Electronics SBE 38 Manual do Utilizador Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Sea-Bird Electronics SBE 38